Handmade Headboard

I made a headboard! I made a turquoise headboard! I am no expert in carpentry….although I did take a community night class and made a blanket chest six years ago. But my Dad IS an expert with all things handy, so since he was in town, he was my helper. Err….ok, I was HIS helper. Same thing wise guy. I saw these plans by a fabulous blogger named Ana. It is a knock-off of this $800 headboard at Pottery Barn. From what I read, this headboard could be made in around 2 hours. Seriously? Sign me up! (The finishing, however, took days, more on that later.) So off to Home Desperate Depot we went. We settled on clear pine, although I did buy 2 boards of El Cheap-O (official name) knotty pine for the lower boards that I knew would be covered. My dad tried to talk me out of buying my wood at Home Depot, claiming I would be ripped off. I should go to a lumber yard to get the best deal. Yea, yea, Dad, I can’t be bothered. What’s the worst that would happen? I overpay by 20 bucks or so? He’s a purist, I am not.
So we came home with a bunch of 1x3, 1x4, and 1x6 boards. The wood set me back about $90 George Washingtons. Cha ching! So far, so good! Then we got busy with my miter saw and drill.


I used screws to put the whole thing together (screw from behind or else use wood filler) instead of nails. Why? Because I don’t own a nail gun. I do own an air compressor so I really should get a nail gun. So here’s my Dad puttin’ it all together while I held the camera. His poor back hurt the next day. Thanks Dad!

Aside from using screws, we made a couple more changes. We didn’t use the 2x4 Ana suggests putting on the very top. We thought it looked fine with just another 1x4 to finish it off.  I didn’t want it to look too rustic. Just a little bit used. This picture shows where we used some wood filler. In the end, I could’ve used the El Cheapo pine for the whole thing because I really liked how those lower boards looked once painted. Note to self.

We also opted to brace the back in the middle with a leftover piece of wood, per some other bloggers’ comments. They thought it was a bit flimsy in the back as is. Nice and sturdy now!
Now comes the fun part—the finishing. I wanted to coordinate with my turquoise dresser. So I pulled out my trusty fan deck (all brilliant women own one) and chose this color to match. I was tempted to stain it a nice dark espresso like my nightstands (which are from Four Chairs) but I shun bedroom sets. I really don’t like everything to match so I opted for paint.

It’s called Turquoise Mosaic 7605D by Millenium. Just take any color from any chip or fan deck to Lowe’s and they’ll enter the name into their magic computer which contains the name of all other manufacturers’ paint colors, and voila, you get the color you want without having to go to a bunch of different paint stores.

After 2 coats of paint, I notice a problem. You can’t see the boards anymore. Argh! It practically looks like I used a sheet of plywood. I want to see the individual boards! Too sterile as is. (*Scratches head with what to do*)

So my Dad came up with the idea of clamping boards to the headboard and chiseling out the seams again. In hindsight, we should’ve chiseled the boards as the very, very first step, and roughed ‘em up a bit. Here’s Paul with chisel in hand separating the boards again. Drag and smoosh, drag and smoosh. This is an official carpentry term. You can see at the bottom where we put a sample of stain to warm it up. Oh, I liked it a lot. Without the stain I will admit I cried out, “It belongs in Romper Room!” Phew, I felt better once the stain went on. I brushed it on with a sponge brush, then wiped it off with an old t-shirt.

I feel better now. The boards can be seen, stain was smooshed and slathered in the cracks, and now it’s time for 3 coats of polyurethane. If it hadn’t been 30-40 degrees this week (it’s April for crying out loud!), my 2 layers of paint, 1 layer of stain, and 3 layers of poly would’ve dried much faster. I had to sand with 600 grit sandpaper in between every coat as well. I wanted it smooth baby! Did I mention the headboard only took 2 hours and the finishing took 4 days? I was tempted to skip some steps, but I wanted this nearly perfect.  And you all know I am not a perfectionist.

Here’s my recipe for finishing: I got nervous with the brightness of the turquoise on a sample board so I added an entire 2 fl oz. of brown craft paint lying around my house to the 1 quart of Turquoise Mosaic. In the end, I’m not sure it made much of a difference. But it made me feel like I was sprinkled with pixie dust in the moment. (“Pixie dust…pixie dust…calm down!” Name that movie.) I applied everything with foam brushes to avoid streaks. I need a paint gun now, don’t you think?


Take down my 4-yr old pale turquoise silk headboard (also made by yours truly), clear out the bed, and get busy.

But I first take a moment to laugh at Paul’s collection of vinyl from the 1980s found under our bed. I approve of the Psychedelic Furs 45, but not too sure about the Paula Abdul and M.C. Hammer records. “Straight up now tell me are you really gonna love me forever..oh…oh…oh…”  Back to work Cynthia.

Paul the accountant gets busy with the drill and some bolts. Hubbies are handy too. Sometimes.

I put the box spring back and take a moment to show you, my bloggy friends, how I make and attach a dust ruffle. I’ve talked about this before. But I’m showing you here that for this silk dust ruffle I used twist pins and not staples to attach it to the box spring. Never make a deck for your dust ruffle. Only sissies do that. Just kidding. Well, not really. You gotta take short cuts where you can.


I put my very expensive D.I. Thriftstore (new, not gross) mattress back. And then add my goodies. In case you care, the quilt is from T.J. Maxx and everything else (well, the bedding at least) is made my me.


















I love it! I love it! I am all for paying good money for furniture, but when something as simple as a headboard can be very easily made for $100 bucks, why pay $800? Thanks again to Ana for the fab plans.